間眅埶AV

i>Clicker Voting Questions

Voting with iclicker student questions

Why doesn't the question show on my mobile device?

Your instructor may have chosen not to show the question on your mobile device. You'll need to ask him or her.

Voting with iclicker remote questions

How do I know if my vote has been received?

You will see a flashing green light which indicates your vote has been received. 

Can I change my response?

You can change your vote as many times as you want until your instructor stops polling.

Do I get graded for my responses?

Your instructor decides how you will be graded for your responses. He/she may assign points for participation or attendance or assign points for correct responses.

What frequency should I use?

Your instructor will notify you what frequency you are using. The default is AA.

How do I change my frequency?

Before you can change frequencies, the i>clicker instructor toolbar must be open. Then, press and hold the power button on the i>clicker remote for 5 seconds. Press the letters of the frequency you want to switch to, i.e. BB. You should get a check mark (or green light) on your remote indicating that the frequency change was successful.

Note: i>clicker 2 and i>clicker+ remotes retain their frequency when turned off, whereas, the original i>clicker reverts to AA when turned off. 

Why do I see the "No base" message or red light?

Here are 2 reasons:

  • You are not set to the same frequency that your instructor is using.
  • The polling session hasnt started.

My grades arent showing up even though Ive been using my i>clicker in class.

Did you register your i>clicker using the instructions given to you by your instructor? Did you get a checkmark or green light from your i>clicker remote when you voted? (If not, replace the batteries and make sure youre on the correct frequency.)

 

Print